Welcome to Jinan Ruby Laser Technology Co.,Lt
Ask&Answer
Common problem on CO2 laser power supply
点击:次    更新时间:2016-06-02 11:46   0
Common problem on CO2 laser power supply

1. Q:High voltage sparking,
    A: The high voltage connector is close to power supply’s steel case.

2. Q:No laser output and fan doesn’t run
    A: Fuse is not connected.

3. Q: Press TEST button(Red),it outputs laser but main control terminal board is not be used to let tube output laser.
    A: CO2 power supply’s low voltage control section is damaged.

4.Q:Current is not be adjusted.
   A: CO2 power supply’s current control section is damaged.

5 Q:Fuse always be burned.
   A: CO2 power supply’s power diode is short circuited.